Dynamix DW 4 FXO Uživatelský manuál stáhnout pdf (Strana 14)

Dynamix IP PBX-100

■ Host: Setting the Trunk to a Dynamic address or a specified IP or FQDN.

■ DialPlan: Define the dialing pan for Trunk.

■ DTMF: User can select DTMF type to be RFC2833, In-band, or SIP-lnfo.

■ NAT Traversal: If the Extension is behind NAT but register to IP PBX-100 which is under

Public IP, you should enable NAT Traversal otherwise the registration should be fail.

■ RTP Mode: User can choose for two type of RTP mode, one is Routed Mode another is

Direct Mode.

■ Port: You can use this to define the SIP signal port if you want to listen on a nonstandard

SIP signal port. (The default SIP signal port is 5060)

■ External Server Address: This field will a l l o w you to set the domain in the SIP From

URI.

■ Maximum Channels: This will limit the maximum channels for this Trunk.

■ Outbound Caller ID: Set the Caller ID if the cal is going via Trunk

Press Apply to save configuration, or press Cancel to quit configuration.

Note:

• For more information about Trunk setting, please refer to 3.Ful WEB Configurations.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 68 69

Žádné komentáře

Dynamix DW 4 FXO Uživatelský manuál Strana 14