Dynamix DW 2 FXO Uživatelský manuál stáhnout pdf (Strana 96)

Tone1OFF .

Tone2ON .

Tone2OFF .

Example:

tone -print

tone 1 480 620 1 1 50 50 1023 1023

usr/config$

Parameter Usages:

-print show all tone configuration

[num] tone index. 1~4 is disconnect tone, 5~8 is remote ring back tone.

For FXO ports Gateway must detect disconnect tone to determine

when to disconnect the call, so user must set disconnect tone of

PBX or PSTN network connected to FXO ports.

When making a call from FXO ports, there are 2 ways to detect

callee has already picked up the call, one is to detect reverse

signal, the other is to detect the termination of ring back tone, so

user must set ring back tone of PBX or PSTN network.

(If user doesn’t know about the frequency of disconnect tone or

ring back tone, please refer to [record] command to detect

frequency.)

For each tone may has 1 set or 2 sets (high and low) of

frequencies. If user wants to set 0 in on/off time, please set “1023”

represent “0”. (ex. tone 1 620 480 8 8 50 50 1023 1023)

(tone “index of tone” “frequency of high” “frequency of low”

“level of high” “level of low” “on time of high” “off time of high”

“on time of low” “off time of low” )

4.2.20 [fxopwd]

This command is for FXO ports.

-------------------------------------------------------------------------------------------------

usr/config$ fxopwd

FXO password information and configuration

Usage:

fxopwd [-print][-add [passwd number][direction number]]

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 216 217

Žádné komentáře

Dynamix DW 2 FXO Uživatelský manuál Strana 96